Below, we can see a sample Z-Bend Die DXF drawing. An origin reference point will need to be placed at the mounting point on the side profile of the tool.

The following text entities are required for a Z-Bend Die:

NAME – This is the name given for the tool.

TONNAGE – This is the tonnage of the tool in kN.

LOWER- This is the lower die valency of the tool.

PIECES – These are the required tool lengths. These are separated by a comma, and if more than one is required, we can use a multiplier to specify the value required.

FLAVOR=ZBendDie – This marks the tool as a Z-Bend Die.

CANFLIP – If the tool can be flipped when mounted, this should be set to 1.

GROUP – This can be used to specify the tool group that this tool would belong to. In this case, it is Z-Bend.

Was this article helpful?

0 0

Please Share Your Feedback

How Can We Improve This Article?

Name

Email

Submit