Back to: TRUMPF Flux
Starting in the jobs page, right click on a job and select the plan option and chose the machines to run the job on, firstly bending machine if available and then the laser machine.
You will see the progress bar of the job changes to a purple colour which like part status can be hovered over with the mouse and you will see the status message, once nesting is completed the progress bar will change to yellow.
Once nesting is completed double click on the job and you will see the parts across the top of the screen and the nests below it, clicking on any part will also highlight on any nests that the part is contained in.
By right clicking on a nest you have the option to edit the nest, which will launch the internal editor where you can move, rotate and alter part quantities. Click on file save or the X to close the editor will save adjusted nest.
In addition to nest edit you can also send the code directly to the machine by right clicking on the nest or a group of them and clicking send to machine at which point the program will be written out to the location that was specified.
