Flyline

Flyline is used for high-speed processing with reduced quality expectations. To work with flyline just select a flyline table from the menu.

Automatic Detection

It is not necessary that the grids are regular for the software to identify and tool up with flyline, they can be partial or staggered.

These grids can be at any angle.

When cutting the circles, the software will cut all the circles in the same direction, clockwise or anti-clockwise depending on the setting that controls the cutting direction for inner contours in the LTT. All transitions when cutting an obround grid are smooth. Where necessary, the software will introduce two curves (5mm diameter) to ensure that the head moves out from one cut tangentially and moves into the next cut tangentially.

Was this article helpful?

0 1

Please Share Your Feedback

How Can We Improve This Article?

Name

Email

Submit